lockup-mate®PLUS+ comes with a comprehensive, step-by-step DIY installation manual with photos. Installation is simple with minimal removal of trim and an adjustable LED/Switch that easily mounts to the A-Pillar.

​

CANBus communication with the vehicle's computers is obtained from the vehicles OBD2 connector.  An OBD2 Y-splitter cable is supplied so your favourite OBD2 device (eg, Ultra-gauge, HUD) can still be used.

​

There are only two wires of the transmission computer harness that need to be cut and soldered for control of the lockup clutch. Installation takes  1-2 hours, which saves you time and money.

​

Watch our Installation videos (below) for more details.